Many of you know that I really enjoy shooting instant film.    I first got hooked on Fuji’s FP-100C a few years ago when I picked up a Polaroid back for the Mamiya RB67.   I was in heaven!   I had never shot the stuff before and I was really enthralled with the beauty of the images.    Since then, I’ve really gotten into Impossible Project‘s films which are another beast in itself (great film).

The cool thing about Fuji’s instant film is that it is peel-apart film and it works on all 100 series Polaroid cameras & film backs.      The not-so-cool thing about this type of film in general, is that when you peel it apart, you remove the print from the negative & the developing solution.  That in turn leaves you with a somewhat vulnerable print that has to dry first before it can be touched & stored.  It’s not really a problem if you’re only shooting a few and can hand hold the print a few minutes until it’s dry.   It does turn into a bit of an issue however when you’re shooting a pack or more of prints fairly quickly and need to store them to dry.  I run into this issue …

A while back, I started to brainstorm on how I could keep the exposed prints & negatives in a safe place when I was out and about shooting.    One day, I was walking around an arts & crafts store and I stumbled upon a paper mache box that looked to be about the size of FP-100C’s prints.   Voila!  It was perfect!

– CLICK HERE TO PURCHASE THIS BOX –

FP-100C drying/storage box
FP-100C drying/storage box
Cut slits into the box, pull the end of the spring through and tie the end
Cut slits into the box, pull the end of the spring through and tie the end
Prints held in place by springs without touching the actual image
Prints held in place by springs without touching the actual image

Once it was complete I finally had a safe place to dry and store the prints/negatives.   I just put it in the camera bag when I’m out and about.

Thanks for reading!

-Justin

0 Thoughts on “Drying Fuji FP-100C prints”

Leave a Reply